Bremsstrahlung radiation

Last revised by Benjamin Li Shun Chan on 20 Feb 2024

X-rays are produced by high-energy electrons bombarding a target, especially targets with a high proton number (Z). When bombarding electrons penetrate the target, some electrons travel close to the nucleus due to the attraction of its positive charge and are subsequently influenced by its electric field. The interaction of the electric fields causes these electrons to slow down and bend around the nucleus (much like a car driving around a corner). In doing so, the electron loses a portion of kinetic energy (KE). The principle of the conservation of energy states that this energy cannot be lost but rather is conserved in the form of photon emission, whereby the energy of the emitted photon is described as:

  • the energy of X-ray photon = initial KE of electron - final KE of electron

    • Thus, the total energy in the system remains the same

    • The closer the electron travels to the nucleus, the more it will slow down and the greater the change in kinetic energy.

X-ray photons emitted in this manner are referred to as bremsstrahlung radiation (bremsstrahlung is German for 'braking radiation'). Bremsstrahlung can have any energy ranging from zero to the maximum KE of the bombarding electrons (i.e., 0 to Emax), depending on how much the electrons are influenced by the electric field, forming a continuous spectrum. The 'peak' of the filtered spectrum typically occurs at approximately one-third of Emax. For example, in a bremsstrahlung spectrum with an Emax value of 120 keV, the peak of the spectrum would be at approximately 40 keV. The unfiltered bremsstrahlung spectrum demonstrates a ramp shape with the probability of photon production being inversely linear with KE. 

The intensity of bremsstrahlung radiation is proportional to the square of the atomic number of the target (Z), the number of unit charges of the bombarding particle (z) and inversely with the mass of the bombarding particle (m): Z² z / m. It follows that light particles such as electrons and positrons bombarding targets of high atomic number are more efficient producers of bremsstrahlung radiation than heavier particles such as alpha particles or neutrons (which can also cause X-rays to be produced through bremsstrahlung, though it's much more unlikely than with electrons).

Most of the X-ray beam consists of bremsstrahlung interactions in the diagnostic range of 30 to 150 kVp. When the applied voltage is less than 70kVp, bremsstrahlung interactions account for ~100% of the X-ray beam. If the applied voltage is more than 70 kVp, the bremsstrahlung interactions accounts for ~85% of the X-ray beam 3. Most of the X-rays produced are of low energy because electron beams have higher chances of striking outer zones of the target atom that produces low energy photons than inner zones of the target atom that produces high energy photons 4.

The efficiency of X-ray production is governed by major factors such as kVp, current, exposure time, atomic number of the anode material, and beam filtration 4.

ADVERTISEMENT: Supporters see fewer/no ads

Updating… Please wait.

 Unable to process the form. Check for errors and try again.

 Thank you for updating your details.